Keys & Licenses

Overview

To fully enable the timing features of Split Second's software, a key and license must be purchased.

The "key" is a physical device containing the license and is attached to the computer.

NOTE:

• Always make sure the date and time are correct on your computer before attaching the key.
  
• Always attach the key before starting the software.

Types of Key

There are two types of keys used with Split Second Software:

• USB Key : These are green, about 1.5 inches long and plug into a USB port.

• Parallel Key : No longer sold. These are light-gray, rectangular about 1.5 x 2 inches with a 25 pin D-connector on both sides. They have a Split Second sticker that says Windows Software. If you have one that says something else, it may be one of the very old DOS software keys which wouldn't work with the current Split Second Software.

About Keys & Licenses

• The same license is used for the National/FIS, Club, and Toolbox software interchangeably. In other words, a FIS race could be timed in the morning and a club race in the afternoon with the same key.
• The key can be moved to any PC computer, and the license would then apply to that computer. Be very careful moving the key between computers that the date and time are set correctly on both.
• If a second key is needed, a second license will be needed for that key.
• Without the key, or if the key is removed while the software is running, the software will go to Demo Mode, where the only timing features are for demo purposes.
• If a key is lost, the licensing with the key is lost too! Take care of the key.
• The key can remain on the computer at any time.

Parallel Key

• If you have a parallel key but now have a computer without a parallel port, you will need to switch to a USB key. There isn't an adapter that will make a parallel key work on a computer without that port. Split Second will need to charge for the USB key since they are sold at cost. If you already have a license set on your key contact Split Second and the remaining license can be set on the replacement USB key.
• If using the parallel key with a parallel printer, simply connect the printer to the key and printing will be as normal.
• A parallel key will only work with a port directly on the computer; not with a port replicator.

Key Driver

A key driver is installed when the Split Second Software is installed. If using the key and software for the first time on a different computer, install the software first and then attach the key.

The first time the key is attached, it will guide you through the rest of the installation process. It will give you a question about where to look for the driver. Choose Install Automatically and be sure to wait until the process is complete before starting the software:

If you get an error during this process or the key isn't recognized see Solving Problems below.

Renewing a License

A key only needs to be purchased once. There is a simple process to update the license in the key:

• With the key attached, start either the National/FIS, Club, or Toolbox software.
• Using the menu at the top of the screen, go to: Software Key | Update License.
• After checking the date, it will give two choices:
  1. If this computer is currently online and you only need to update your license(s) you may do so directly through the software. You will be redirected to a web page for secure payment and the key(s) will be automatically updated.
  2. If not online or you need something in addition to license(s), you will be directed to a screen that gives a key code for the attached key. The key code is entered with the order (online or over the phone), and once the order is completed a corresponding update code will be given back. Entering the update code on the same screen will update the license.

Solving Problems

Not currently available. If you experience any problems please call Split Second @ 1 (802) 879-0061.

Computer doesn't see the Key